BROADCAST SCHEDULE:

January 22, Epicenter Christian Conference: 9:00 am – 5:30 pm
January 24, CCF Sunday Worship Service: 8:00 am – 9:30 am, 10:00 am – 11:30 am, 12:00 pm – 1:30 pm, 1:30 pm – 3:00pm

Watch on Internet TV now

SATELLITE TV INSTALLATION GUIDE:

1) I want to watch the Joel Rosenberg Epicenter Asian Conference channel Live on Satellite TV, what do I need?

• Satellite Dish with cable and  LNBF
• Television Set with A/V cables

2) I have a satellite dish and cable, how do I set it up to catch the Joel Rosenberg Epicenter Asian Conference channel?

1. Initially set the antenna to 118° and  55° for the azimuth and elevation respectively
2. Configure the Receiver Box to the following parameters:
   • Frequency = 12544MHz
   • Symbol rate = 21.4286 Msps
   • LO= can be found on the LNBF (ie. 11300,10600,10750)MHz.
   • Polarity = Vertical
   • FEC = 5/6
3. Move the antenna sideways to +-8° of 118° until the maximum signal will obtain.
4. Move the antenna upward/downward to +-8° of 55° until the maximum signal be obtain
5. Maximum signal can be seen on SIGNAL STREGNTH and SIGNAL QUALITY.

3) How do I test if my satellite dish and cable is set up correctly?

• The following channels must be received:
  • FLIP TV2, AMA Channel, GOD TV, YR ASIA TV, KARAOKE TV, MAGIC 89.9, GV FM 99.1, GV AM792 and TV Maria.
• Pls. tune in to KARAOKE TV to test the A/V while waiting for the Advance Play-out or the Live feed.
• If you can view these changes, you’re successful. Congratulations!!!

TROUBLESHOOTING GUIDE:

• Signal should not be obstructed.
  • Path of the signal going to the antenna should not be obstructed.
• Repeat the procedure from 2.1-2.5.
• Please check all cable connections. They must be properly attached.
• LNBF
  • Please also check the orientation of the LNBF. (Orientation may vary depending on the design of the LNBF. But it should be tilted at 5 O’clock or 7 O’clock, facing the antenna.
  • Please also check the Input frequency of the LNBF. It should be within the range of the downlink frequency (DL=12544MHz).
• Please check that the DC power going to the LNBF is correct.
  • Disconnect the F type connector from the LNBF.
  • Measure the DC power using VOM, DC is present (16VDC to 24VDC)
• Connect everything and test.